Xexun TK-103

piskorowski
Check input rules once more
http://docs.gurtam.com/en/hosting/user/ … noj_pochty
Or maybe the phone number you're entering already exists in the system.

The commands are the same for SMS and for GPRS.  I create commands on the unit properties with the same text that I send on the SMS configuration.

Hope this helps...

C U

These are the commands you need to configure TK103
1  begin123456
2  ip(xxxxxxxxx)port(YYYYY)   -   remember to include the alphabets ip & port  before the ip & port numbers
3 apn123456#(APN Address)
4 number(Sim number)
5 web123456
6 at120sum0

Hope it helps

Friends something very strange is happening, I am newbie in wialon hosting, what happens is that I have 120 unds tracking, among these 20 units have GPS103-be Xexun 103-2 Brazil, everyone stop sending location to servers hosting wialon. I'm going crazy, I can not solve. Has anyone had this problem before?
Remember that the same happens in GPS-free orange trace servers. Recofiguração already realized from the beginning with "begin123456" anyway pessiste the default command.

thank

Hi Renato,

do you have other GPS Tracking hardware which you can use to test the SIM-CARDS?

For Debugging i would recomend using the following steps:
1.) take one unit which is not sending anymore
2.) take simcard out of this unit and put it into a mobile phone, configure APN and do a ping test (download a ping app) to 193.193.165.165
if that works, with SIMCARD and Network everything is fine.
3.) reset device by sms and configure the unit fully again. if it still does not send any data, check http://id.wialon.net/ with this device if you receive any data
4.) if SIM is ok and id.wialon.net also show receiving data, than something in WIALON receiving script must be changed which is not fully compatible with your devices. contact support@gurtam.com with the ID you are testing and the steps you already did for checking.

Wolf.

p.s. all this xexun tk-xxx devices totaly sucks. they are not really stable and always forgetting their configuration or just stop connecting via gprs.
i never got a device in my hands which is really stable. remember: you always get what you pay!

Renato, this should be related to timezone. The best way is to e-mail to support@gurtam.com with details, then you'll be asked to point device to debug IP and then withing 24 hours I suppose your issue can be resolved.

Hello All,

I have purchased a Xexun Tk-103-2 and i am trying to configure the ignition sensor for the device. I have tried using the parameters mentioned on the http://gurtam.com/en/gps_tracking/gps_h … ?id=280015 however no luck.

Has anybody worked with this device and successfully setup the ignition status. As the Vehicle just shows moving all of a sudden.

TK-102 or TK-103?

Hi, I´ve been working on this issue for several days now and didn´t succeed. On another portal (operated by the seller of the unit) the device delivers satisfactory outputs. Not on GPS-Trace so far.

I established the connection on the wialon 193.193.165.167 20222 Check-site and my device was identified as a TK-103 with 12-digit ID-Number (xxxxxxx39647). This seems strange since the device looks like a Xexun TK-102 and accordingly should be identified by its 15-digit imei.

Afterwards on the GPS-Trace-site I did not succeed in adressing the device. I assumed that this may be caused by the discrepancy in the imei characteristics. Therefore I tried it both ways: TK-103 with the abbreviated 12-digit imei and TK-102 with the full imei - no joy.

Does anybody know a workaround or alternative solution?

What protocol does this equipment use?