Тема: Meitrack VT340
How can I use the engine shut off on Wialon plataform, the GPS device is a Meitrack MVT340
Thanks
2
15/09/2012 22:17:23Meitrack VT340
- wwbusch aka Buwo
- Gurtam Partner
- Неактивен
Re: Meitrack VT340
Hi RVV352:
First check http://www.meitrack.net/images/protocol … _V1.26.pdf for commands (page 17).
1.) you can add a command with 0000,C01,0,ABCD (use output1)
2.) you need sms credits to send this command
3.) you can also play arround with sending command by gprs, but this makes only sence, if you can be 100% shure, that device is ALWAYS connected via gprs and sending minimum of all 4 minutes a position (as i remember there is a timeout of 5 minutes on wialon side)
4.) in europe its forbidden to disable engine via sms or so (but in mexico maybe not :-)
Wolf.
Politeness dictates it to write his name on a post
3
19/07/2013 06:57:08Meitrack VT340
Re: Meitrack VT340
hi im working with meitrack brand (mvt340) and i dont know how configurate the engine ignition sensor.
Thanks in advance.
Yikin Loo
Santiago, Chile.
4
21/07/2013 16:52:01Meitrack VT340
- JohnG
- Gurtam Partner
- Неактивен
Re: Meitrack VT340
You use port 5/IN2 (positive trigger) to capture the trigger from the ignition switch. Make sure that the port is connected to a wire that has power continuously whilst the vehicle is running not to one that is only energised when starting.
Make sure that the port is enabled using the configurator so that the trigger can be captured.
Regards
John
Phoenix Solusi
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.