Seat Belt Alarm

KATHIRI as per the teltinika description https://wiki.teltonika-gps.com/view/FMB … ameters_ID , din2 corresponds to the id 2. Check data messages in your account in Wialon. The unit should be sending parameter «io_2». If it does, that is the parameter for your sensor. Create a custom digital sensor basin on this parameter and it will be showing you either ON or OFF status.

Next, create a notification to control that sensor. Define range from 1 to 1 or from 0 to 0, to control status depending on the values of the sensor.

You can have two sensors combined into one. Depending on the exact status, that you want to control during movement, the solution might be a bit different.

However, you can have Door sensor, then Speed sensor (using «speed» parameter) and their combination with the help of the formula:
[Door sensor]*[Speed sensor]
That summary sensor can be used for reports or notifications. If a unit is moving, speed is above a certain limit or just above 0kmh. It is then miltoplied by door sensor value. Thus, the sensor is activated when both conditions are fulfilled (both sensor are equal to 1).