1

Meitrack VT300

Тема: Meitrack VT300

Hi,

I was trying to reconfigure the VT300/310 meitrack hardware and succeeded to a good extend bodies not complete the following.

1. As per image I cannot figure out the ACC wire as they talk about two wires (green and blue) to connect.
2. In sensors, the engine ignition sensor parameters are not found (eg. In1, In2 etc)
3. How to set the angle to 15 degree by sending SMS commands
4. To save data, how can i set the sleep mode when there is no movement or sign is in off position

Regards,
Abraham

2

Meitrack VT300

Re: Meitrack VT300

Hi Abraham,

do you use VT300 or VT310? its a big difference!
The VT300 has no ! sleep mode, the VT310 (if its an original Meitrack) has sleep mode.

We always use DIN5 as it is positiv triggered, DIN1-DIN3 is NEGATIV triggered!
(you need to pull the input to GRND to get a logical high.

For Veer Report we set it to 15 deg with W000000,036,015

For Manual:
http://documents.mx/documents/vt310-use … l-v61.html

The original Meitrack HW is very very stable, we are running them since 2008. (But we bought the last from them hihi, so no chance to get any again)

Wolf.

Politeness dictates it to write his name on a post
3

Meitrack VT300

Re: Meitrack VT300

Hi Wolf,

I pulled it out from a truck, not sure which model, but attaching a image of it.

Abraham

4

Meitrack VT300

Re: Meitrack VT300

Abraham,
no attached picture.

Send me an email to wolfgang (at) hilltronic.de or  "wwbusch" in skype.

Wolf.

Politeness dictates it to write his name on a post