1-Wire RFID Reader by ORMAT

Hello Shabbir.Sarrahraj,

We just checked the specs of LMU-2600 by ColAmp. It supports Driver ID on 1-wire using iButton.
So, our product should work great on this device, as it completely emulates DS1990A iButton all specifications on 1-wire.

You may buy the samples; contact: info@ormat.in

Hello Wolf,

"Button always plugged in" scenario is not possible with this RFID Reader, due to its generic design. Our customers are using it for Authorized Driving to enable Ignition. Every time, to turn on the Vehicle, one flash of authorized driver card is required.

So, Every start of vehicle will have a driver ID associated for that trip. When trip ends and the vehicle starts again, there's a driver ID available. Hence, trip duration (Ignition ON through Ignition OFF) is the associated driver's work time.

Best Regards,
ORMAT

Hello Wolf,

Yes. We accept firmware changes!

It already has a LED (bi-color: Red/Green) and a Buzzer. Basically, LED & Buzzer , now indicates Ready status & Successful card read status.
The unit has in-built 1-Wire disconnection detection & audio-visual notification of disconnection as well.

Thank you
ORMAT

@In Track,

Our 1-Wire RFID reader reads popular and low cost 125kHz cards and acts as iButton reader.
You can replace iButton reader & use our 1-wire RFID Reder and instead of iButtons , you can use low cost RFID cards.

This will help to add RFID functionality to even basic trackers that supports 1-Wire iButtons.

Please check the datasheet attached. For any further information, you may please write to info@ormat.in

Thank you

Hi ,

We also have a Dallas- iButton / 1-Wire reader for the Mifare cards !  Compatible with ISO/IEC14443-3-A standard !
Can be used on any GPS Tracker with the Dallas iButton bus like Teltonika, Ruptela, Atrack etc etc

It emulate theDallas iButton key .. !  The most simple solution

And : RFID 13,56 Mhz !!!

Just send PM for more info

regards

Baltika
The Netherlands

Hi David,

You stil need the magnetic readers ? What quantity ?

regards
Baltika