1

Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Topic: Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Hi Gurtam,

Could you please add new metrics from "Fuel Level" sensor type as:" %". Since amwell series giving "%" value from Fuel Level sensor as we installed. Currently the metrics only available in "gallon" & "Liter". Thanks.

  • Changing Metrics from Fuel Level Sensor Type (Amwell Series)
2

Changing Metrics from Fuel Level Sensor Type (Amwell Series)

(edited by wwbusch aka Buwo 01/12/2014 16:08:46)

Re: Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Hi Hendrian,

you can just calculate it :-)

if you receive data in % and need to know it in litres, just do some easy mathematics in the configuration of fuel level sensor (please see here a FLS of a 200 litre tank,
the formula (for our CANBUS data is) Fuel Level in Litres = Sensordata (in %) * 2 (for the 200 litres) * 0.4 (because of GPS HW calculation, a internal factor)

Enjoy
Wolf

  • Changing Metrics from Fuel Level Sensor Type (Amwell Series)
Politeness dictates it to write his name on a post
3

Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Re: Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Hi Wolf,

Is it apply to any kind of FLS?. Anyway thanks for advise.

4

Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Re: Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Hi Hendrian,

as i remember you can use any kind of calculation in sensors.

But only the "Fuel Level Sensor" is defined in litres.

Have a look to this:
http://docs.wialon.com/en/hosting/cms/u … sors/param

(Whau, Wolf is looking and using at DOKU :-)))))

Enjoy

Wolf.

Politeness dictates it to write his name on a post
5

Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Re: Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Hi All,

Anyone still using these units? We still has some on our fleet but when we upgraded to 2304, they have stopped working.

We have been using port 20513 when setting our units.

Will appreciate your feedback on this.

Regards,
Shalin.

6

Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Re: Changing Metrics from Fuel Level Sensor Type (Amwell Series)

Dear shalin.lazar, as I can see this case was resolved in corresponding ticket sent to support@gurtam.com
If any additional support required, please, write us.

Thank you!

Anton Zinovyev
Technical Care Engineer (L2)
Wialon