Вы не вошли. Пожалуйста, войдите или зарегистрируйтесь.
Hello
Please first Connect to i-Button port of Calamp LMU (on 26XX parts pins 16 & 17) then in the script add this 2 lines (see images)
Data from id.button goes to an accumulator, in wialon see messages and look for the accs 6 & 7, because the whole data fit in to 32 bits (only lower 32bits are stored instead 64 bits as usual on ID buttons)
you can PM'me if want more info,
i dont know about ibutton usage. i just purchased ibutton device and connect with VTS device and checking what data comes ?
it must have to configured first ? how to configure ? if you know about any model kindly suggest me i will put order for buy.
Shabbir, you should hire small_gprs for a few hours to do a remote session.
It will be worth the money!
Wolf.
Hello dear
please find image below, i did as you said. where i find ibutton values ?
Hello
Please first Connect to i-Button port of Calamp LMU (on 26XX parts pins 16 & 17) then in the script add this 2 lines (see images)
Data from id.button goes to an accumulator, in wialon see messages and look for the accs 6 & 7, because the whole data fit in to 32 bits (only lower 32bits are stored instead 64 bits as usual on ID buttons)
you can PM'me if want more info,
not sure it is ID only iButton like DS1990A. It's DS1971 or other models..
Hello,
which ibutton can be used in LMU2600 series CalAmp device ? and how to use ? i have this accessories but there is no messages are getting in wialon interface. how it connect and use please let me know.
