Вы не вошли. Пожалуйста, войдите или зарегистрируйтесь.
We have Teltonika FMC640 device to retrieve speed, heat, and load of the trucks. Then we want to set our limit of speed, heat, and load and make a reports in our site so we can see what units that had over limit in speed, heat, and load. So, how we set the template for the type of the reports ?
Point :
1. Overspeed Reports
2. Overheat Reports
3. Overload Reports
Thanks
Hello,
It can be done in several ways. Let me describe one of them.
1. Overspeed Reports
Set speeding settings on the Advanced tab of unit settings.
Use table Speeding to see the result.
2. Overheat Reports
Create custom digital sensor based on parameter from temperature sensor.
Add the Calculate table as it is done in the example. But instead of 0.5 set the value of maximum allowed temperature.
Use table Digital sensors to see the result.
3. Overload Reports
Create custom digital sensor based on parameter from weight sensor.
Add the Calculate table as it is done in the example. But instead of 0.5 set the value of maximum allowed weight.
Use table Digital sensors to see the result.
