Topic: Fuel consumption calculation using CANBUS data.
Hello! Good night everybody.
I'm starting to calculate the consumption using the data coming from the CAN, we use the device IDP782 of skywave for this and the data coming from the can are real, check with reality, but we are not able to properly configure the reports.
we did the calibration of the tank and for this we created a conversion table for the values coming from the can be treated properly.
the problems I often face are:
1. wialon mobile does not display consumption after an trip
2. In the printed report is presented values of small fuel fill without actually supplying, I need guidelines to help minimize the incidence of this type of situation.
3. I am having difficulty configuring the partial consumption sensor since the parameter when coming in the hour shows the consumption in L / H and at other times L / 100km, what would be the best way to configure it?
thank you !