Queclink GV200

GT SOS,  GTFRI may be the only supported

Does anybody knows correct AT command to enable SOS and Digital port 3 or 4 in order to activate a panic button over GV100 quectel?

Do you have the Manger tool for GV200 ? you can copy and paste from the Manger-tool and send via SMS , if otherwise let me know I can send you the commands.

01. Quick Start settings -

AT+GTQSS=gv200,apnname,user,password,3,,2,193.193.165.165,20420,0.0.0.0,0,,60,0,0,,FFFF$

(Replace-  apnname,user,password with your ISP settings)

02.Global Config.

AT+GTCFG=gv200,gv200,gv200,1,0,0,,3F,2,,3FFF,0,0,0,300,0,1,0,0,1F,0,FFFF$

(with power saving when Ignition is off)

03.Reporting

AT+GTFRI=gv200,1,0,,0,0000,0000,,5,1000,1000,,15,600,0,,,,FFFF$

(Fixed time , 5 seconds update)

+ Above should get your Gv200 connected to the Wialon server  , if does not work , please change the IP of the 1st command to 193.193.165.167 and check on id.wialon.net  if the device IMMIE reflects on the page .

+ Im using GV200's default password in these commands  , if you have changed it please replace 'gv200' with the password you've set.

+  If you have any sensors connected you will have to configure them with more commands.

+ If you write to Qucelink  , they will send you the manger tool , You need to have the correct UART cable to configure the device using your computer.

update the ticket if you were able to get the device connected .

just leave them blank ( no space) , like below .

AT+GTQSS=gv200,apnname,,,3,,2,193.193.165.165,20420,0.0.0.0,0,,60,0,0,,FFFF$

Not sure how to re-set the password , you might have to write to queclink.

do you have the password ?if you dont have the password ,
email support@qucelink.com they will help you out.

Why dont you insert a sim and send the comands with default password . It might work.

good to know that reflashing the FW helps.
On ATrack HW even that does not help.

Wolf.

buen día colegas

alguno tiene un manual de configuración via SMS para estos equipos