Тема: How can i use output?
i connected buzzer to output of gps tracker.
Now what command i use the enable and disable output of tracker?
i want to when overspeeding of fixed limit, i would enable output of tracker else disable output.
It's my life
1
03/02/2017 03:39:42How can i use output?
- b.chuka
- Wialon fan club
- Неактивен
2
03/02/2017 17:32:51How can i use output?
Re: How can i use output?
What is the tracker Make and the model ?
Usually the commands can be found in the Tracker's user manual.
b.chuka пишет:
i connected buzzer to output of gps tracker.
Now what command i use the enable and disable output of tracker?
i want to when overspeeding of fixed limit, i would enable output of tracker else disable output.
Sint
3
05/02/2017 07:13:18How can i use output?
Re: How can i use output?
I did a script, (funny) for buses, wich make a sound at speed 1, and fast alarm sound at speed 2 (high speed) using calamp device, here is the code
--
Spread the AVL- World
Spread the AVL- World
4
06/02/2017 10:45:02How can i use output?
- b.chuka
- Wialon fan club
- Неактивен
Re: How can i use output?
I am using trackers of TELTONIKA. fm1120, fma920, fm1110 etc...
It's my life
5
07/02/2017 20:01:54How can i use output?
- wwbusch aka Buwo
- Gurtam Partner
- Неактивен
Re: How can i use output?
Imaging, you lose gprs connection or device did not receive command to disable buzzer. Drivers will love your new function!
I would never use any commands which needs working gprs connection
Wolf.
Politeness dictates it to write his name on a post
6
28/05/2017 10:53:58How can i use output?
- JohnG
- Gurtam Partner
- Неактивен
Re: How can i use output?
You have to drive the command directly from the unit itself as if connectivity is lost the command will not trigger, trigger at the wrong time or as Wolf said it will not trigger the stop. You cannot rely on communications network for these types of triggers.
Phoenix Solusi
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.
Mobile Visible Secure
Specialists in data acquisition and analysis for mobile and fixed assets. Integration in to content management systems is a specialty we have.
7
29/05/2017 10:37:08How can i use output?
- ldibra
- Wialon fan club
- Неактивен
Re: How can i use output?
If you use teltonika FM1120, you should open FM11XX configuration and then go to Scenarios and enable over speeding. Chose the device output and its done.
Make sure the voltage requirements of buzzer support operation on 12V .
There is and other way, via sms event notifying. Its also included in FMXX configurator.