Вы не вошли. Пожалуйста, войдите или зарегистрируйтесь.
hello
i have a cache server to save gps data from devices
now we get data on our server and then sending them to wialon
i have 50 device and 50 account
but my server send 40-43 packet to wialon each minutes so there are a lot of packet waiting to send
is there any way to send more packet ?
Hello
What protocol do you use to send data to wialon?
Hello
What protocol do you use to send data to wialon?
tcp with python
tcp with python
And what about protocol?
Wialon IPS or Wialon Retranslator or something else?
roozgar пишет:tcp with python
And what about protocol?
Wialon IPS or Wialon Retranslator or something else?
im using the original device format
mega stack mt60
im sending something like this:
$MGV002,<imei>,12345,S,231116,105258,A,3544.7068,N,05130.1272,E,0,9,00,1.24,0.0,0,,,432,11,11,4208,23,,,,,,,,,00,17,Timer;!
to a custom port of wialon
roozgar our Wialon datacenter analyses more than 800 000 messages per minute.
http://gurtam.com/en/datacenter
Your 40 packet's can't make any queue.
It seems that the problem is somewhere on your cash-server.
roozgar our Wialon datacenter analyses more than 800 000 messages per minute.
http://gurtam.com/en/datacenter
Your 40 packet's can't make any queue.
It seems that the problem is somewhere on your cash-server.
im speaking about socketing limits
i cant send any request until last one complete
because i cant open two soscket on one ip port on my machine
the 800000 request is made by 800000 unit!!
this is my code
try:
sistr='$MGV002,'+devimei+',12345,S,'+devdate+','+devtime+',A,'+lat+',N,'+lon+',E,0,'+satcount+',00,'+hdop+','+speed+',0,,,432,11,'+lac+','+cid+','+gsmQ
print(sistr)
clientsocket = socket.socket(socket.AF_INET, socket.SOCK_STREAM)
result = clientsocket.connect(('193.193.165.165',21033))
clientsocket.send(sistr)
data = clientsocket.recv(1024)
print(str(datetime.datetime.now())+' -> send completed :'+format(sig[0]))
clientsocket.close()
except:
print(str(datetime.datetime.now())+' -> connection to tcp server failed!!')each request need up to 1 seconds to complete
so i can send 60 request per minutes
roozgar, you are blocked by tcp connection open/close sequence. Try open connection and send as much data as you need, then close it. No need to open/close it constantly. Or you can try to use UDP to send datagrams if this is supported by receiving side (check device page).